Logo

FMI 2015 CAT Fault Code

Pump to Attachment #2 Head End Spool Not Responding to Command

Cause :

The job of the Starter Relay Circuit is to provide a power source to the starter to crank and start the engine. Depending on the specific vehicle and its drivetrain configuration, there can be multiple components involved in this process.If serial data communication is lost between any of the LIN devices on the LIN bus network, the master control module will set a no communication code against the non-communicating LIN device. The Diagnostic Trouble Code (DTC) sets when a supervised periodic message that includes the transmitter device availability has not been received.


Don't forget ! When a fault code pops up, CAT's Uptime Center is automatically notified via an cellular link, and it alerts the truck's owner by prearranged methods, usually email or phone calls.

About | Contact | Privacy

Copyright © 2019 All rights reserved. Cat OBD,EDC,DTC and Engine Trouble codes informations.

CatFaultCodes.com is not a part of Cat brand. CAT is a trademark that we trust.