Logo

CID 2068 CAT Fault Code

Pump #1 Control Spool Solenoid

Cause :

The job of the Starter Relay Circuit is to provide a power source to the starter to crank and start the engine. Depending on the specific vehicle and its drivetrain configuration, there can be multiple components involved in this process.Engine started, engine running, and the PCM detected a high voltage present at the PCM for 3 minutes after the engine started. The Starter Relay Control Circuit High Voltage test monitors the voltage signal that is sent from the ignition switch.


Don't forget ! When a fault code pops up, CAT's Uptime Center is automatically notified via an cellular link, and it alerts the truck's owner by prearranged methods, usually email or phone calls.

About | Contact | Privacy

Copyright © 2019 All rights reserved. Cat OBD,EDC,DTC and Engine Trouble codes informations.

CatFaultCodes.com is not a part of Cat brand. CAT is a trademark that we trust.